I installed this LED unit, its a Edge 2 LED taillight. It's made to mount up under the fender but I decided to mount it above the fender to keep it out of harms way. I think it really looks good on the bike. You remove the stock light unit from the fender and install the new light over the hole. One note, the license plate bracket that came with the unit is to small to fit a standard license plate...Hmmmm. So I had to make a modification to make the plate fit right., ended up backing the plate with a piece of aluminum to brace the plate.

I'm very happy with the light. It really cleans up the rear of the bike, its very bright and I don't have to worry about burnt out bulbs.

Here's a link to the light: CLICK HERE










Hodakaguy

Anything's better than the stock XRR tail light!

I might have to try that one out. Do you know if the "AC/DC" means it'll work off stock wiring?

Kind of confusing that it says AC/DC on the e-commerce site.